MTN/1109I, IC
ATEX and IECEx Group I & II certified. General purpose, top-entry, constant current accelerometer with isolated AC output. Made from robust stainless steel throughout for long term vibration analysis in harsh, hazardous gas and dust environments. 3 wire device, requires -24V supply.
Sealed to IP67 and includes 3-pin 62GB connector or stainless steel overbraided ETFE cable and is available with a wide range of mountings.
- Environment: Industrial, Hazardous, *Mining
- Frequency Range: 2Hz - 12kHz
- Temperature Range: -55°C – 140°C
- Output: AC 100mV/g
- Entry Type: Top Entry
The MTVS0004 Vibration Switch offers a low cost, simple to install and operate solution to protect all sorts of rotating machinery; motors, pumps, fans, gearboxes etc. It’s durable case with high IP rating is suitable for long life in harsh industrial environments. Measurements are made in velocity and compatible with ISO10816 Machine Vibration Severity Test. Just bolt the unit to a flat surface on your machine, set the appropriate alarm and trip levels, connect the relays to switch alarms or to power down the machine then connect to the power supply for continuous protection. For restricted access situations or where the vibration must be monitored on bearing housings external vibration sensors may be used with mounting diameters down to 15mm diameter. Choose either latching alarm relays requiring operator reset following an over vibration incident or non-latching relays to automatically resume operation as soon as the fault has cleared.
General purpose, side-entry, constant current accelerometer with isolated AC output. Made from robust stainless steel throughout for long term vibration analysis in harsh environments.
ATEX and IECEx Group II certified. Submersible, general purpose, side-entry, constant current accelerometer with isolated AC output. Made from robust stainless steel throughout for long term vibration analysis in harsh underwater environments and areas with constant moisture or condensation.
ATEX and IECEx Group II certified. Submersible, general purpose, side-entry constant current accelerometer with isolated AC output. Made from robust stainless steel throughout for long term vibration analysis in harsh underwater environments and areas with constant moisture or condensation. Internal electronics are isolated to minimise noise with increased bias voltage stability
ATEX and IECEx Group I & II certified. General purpose, top-entry, constant current accelerometer with isolated AC output. Made from robust stainless steel throughout for long term vibration analysis in harsh, hazardous gas and dust environments. 3 wire device, requires 24V supply.
General purpose, top-entry, constant current accelerometer with isolated AC output. Made from robust stainless steel throughout for long term vibration analysis in harsh environments. 3 wire device, requires 24V supply.